Dell PowerVault MD1200 Direct Attached Storage
Versatile, high-capacity direct-attached storage DAS
Versatile, high-capacity storage for mainstream applications, with optimal performance in sequential (streaming) applications.
SKU
MD1200
Specification
Operating System
- Refer to RAID Card for details on supported Operating Systems:
PERC H810
Connectivity
- Support for the following configurations:
Unified mode (single path) for daisy chaining of up to 8 enclosures per PERC H810 (4 enclosures per port, single path)
Unified mode (redundant path) for daisy chaining up to 4 enclosures per PERC H810 (4 enclosures connected to both ports via redundant path cabling)
Split mode with dual Enclosure Management Modules providing direct connectivity to drives 0 through 5 and a separate connectivity to drives 6 through 11.
Environmental Operating Conditions
- Temperature:
Operating: 10° to 35°C (50° to 95°F) with maximum temp gradation of 10°C per hour
Storage: -40° to 65°C (-40° to 149°F) with temp gradation of 20°C per hour
Supports Fresh Air cooling, up to 35 degrees Celsius
Relative humidity:
Operating: 8% to 85% (non-condensing) with maximum humidity gradation of 10% per hour
Storage: 5% to 95% (non-condensing)
Altitude:
Operating: -16 to 3048 m (-50 to 10,000 ft)
Storage: -16 to 10,600 m (-50 to 35,000 ft)
Power
- Two fully redundant power supplies; supports DC power
Wattage: AC - 600 W; DC – 700 W
Heat dissipation: AC - 2047BTU/hr; DC - 2388 BTU/hr
Voltage: 100-240 VAC, auto sensing; 48V DC
Frequency: 50/60 Hz
Amperage: 8.6 A at 100 V, 4.3 A at 240 V
Available Drive Power (per slot)
Supported drive power consumption (continuous):
up to 1.16 A at +5V
up to 1.6 A +12V
Management
- 2 Enclosure Management Modules(EMM) provide redundant enclosure management capability
Storage
- Drives1
Up to twelve (12) hot-pluggable SAS Hard Disk Drives (HDDs) at 7.2K, 10K and 15K rpm and SAS Solid State Drives (SSDs)
Drive performances and capacities
3.5” 6Gbps SAS:
HDD 15K – 300GB, 450GB, 600GB
HDD 7.2K – 1TB, 2TB, 3TB, 4TB
HDD 7.2K NL-SAS 512e – 6TB3.5” 12Gbps SAS:
HDD 7.2K NL-SAS 512e – 6TB, 8TB, 10TB
2.5” 6Gbps SAS with 3.5” carrier:
HDD 10K – 300GB, 600GB, 900GB, 1.2TB
HDD 10K 512e– 1.8TB
SSD – 400GB mainstream SLC
SSD – 200GB, 800GB value SLC
SSD – 800GB RI MLC
SSD – 200GB, 400GB WI SLC2.5” 12Gbps SAS with 3.5” carrier:
7.2K HDD NL-SAS 512e – 2TB
SSD – 200GB, 400GB, 800GB, 1.6TB MU MLC
SSD – 200GB, 400GB, 800GB WI MLC
SSD – 800GB, 1.6TB RI MLCMaximum Capacity (per enclosure)
Up to 120TB when using 12 x 10TB NL-SAS 3.5" HDDs
Expansion Capabilities
PERC H810 Host-RAID adapter enables expansion to 8 enclosures (4 enclosures per port)
Chassis
- Height
8.7cm (3.43 inches)
Width
48.2cm (18.98 inches)
Depth
59.4 (23.39 inches)
Weight
28.39 kg (62.6 lb) (maximum configuration)
8.84 kg (19.5 lb) (empty)
RAID
- PERC H800 supports RAID levels 0, 1, 5, 6, 10, 50 and 60.
Back-Panel Connectors
- SAS connectors (per EMM)
1 SAS (SFF 8088) "IN" connector for connection to the host
1 SAS (SFF 8088) "OUT" connector for expansion to an additional enclosure
Serial connector (per EMM)
1 6-pin UART mini-DIN connector (for factory use only)
LED Indicators
- Front panel
1 two-color LED indicator for system status
2 single-color LED indicators for power and split mode
Drive carrier
1 single-color activity LED
1 two-color LED status indicator per drive
EMM
3 two-color LED status indicators: one each for the two EMM SAS ports and one for the EMM status
1 single-color Unit Identification LED for each EMM
Power supply/cooling fan module
3 LED status indicators for power supply status, power supply/fan fault and AC status
Connector
-
SAS connectors (per EMM)
1 SAS (SFF 8088) "IN" connector for connection to the host
1 SAS (SFF 8088) "OUT" connector for expansion to an additional enclosureSerial connector (per EMM)
1 6-pin UART mini-DIN connector (for factory use only)
| Manufacturer | Dell |
|---|
